How do I check or change my LD5 L-band beam? How do I change the cut off angle from my LD5-B or LD5-C for DP Trials? How do I check the IP address of my LD5? How do I configure an LD5 to receive RTK corrections? How do I configure LD5 (A & B Variants) COM ports & Ethernet output? How do I configure LD5 (C Variant) COM ports & Ethernet output? How do I configure LD5 NMEA message output? How do I configure my LD5 to use the Apex service? How do I enable and output heading from my LD5-C? How do I enable an LD5 for a heading? How do I extract LD5 internal data? How do I factory reset my LD5 Unit? How do I manually enter an L-band satellite frequency on my LD5? How do I remove satellites from my LD5-A for DP Trials? How do I set up cross corrections on an LD5 unit? How do I tell which LD5 version/variant I have? How do you set up and log NMEA data from an LD5 unit? I have just changed beams and my station list is not fully populated- Why is this? I wish to enable External/MF corrections on my LD5-A for use in the position solution. Why is the 3rd Party menu item greyed out in the Routing menu? What are the different LD5 operating modes? What are the serial pin-outs of the LD5? What are the tracking capabilities of the LD5 and what services are available? What direction is the heading on my LD5? What is the expected latency from one PPS to the NMEA ZDA telegram on the LD5?
How do I check the IP address of my LD5?
To check the IP address of an LD5, from the home screen navigate to Config > Network where the IP address is displayed.
The IP address can be edited in this page if required.