Configuring a Verify DP Heading input on PORT3 Configuring a Verify DP Heading input through USB For LD2 What is the expected latency from one PPS to the ZDA telegram? Guia rápido do LD2 da VERIPOS (LD2 Quick Guide - Brazilian Portuguese) How can I change the IP address of my LD2(S) when using Verify-DP? How can I determine what L-band firmware versions are installed on the LD2/LD2S? How do I check the GLONASS option on my Topcon GNSS Receiver in an LD2 IMU? How do I check the L-band reception status of my LD2/LD2S demodulator? How do I check version number of my LD2? How do I configure a Position Output on port P1 of my LD2/LD2S? How do I configure my LD2 (Topcon GPS card) to output a ZDA and 1PPS string from Port 1 of the LD2? How do I configure my LD2 to use the Apex service? How do I manually select MF Stations on my LD2 IMU? How do I Remove Standard+ Service in my LD2/LD2S? How do I select MF or HF Auto Frequency on my LD2? How do I upgrade the GLONASS option on my Topcon GNSS Receiver? I have just changed beams and my station list is not fully populated why is this? LD2 DP Bridge Card LD2 Installation Manual LD2 Operations Manual LD2 Quick Guide LD2 Setup - Configuring PPS & ZDA Output from Topcon GPS Card Selecting An LD2 L-band Beam What are the tracking capabilities of my LD2 and what services are available to my unit? What data is available on the LD2 Ethernet port? What do the status LED's on the front panel of the LD2 show? What is demodulator Channel 16 used for and how I configure it? What NMEA telegrams are available for output from the LD2/LD2S?

How do I check version number of my LD2?

The system information number is unique to each LD2 system version. The information number of the LD2 can be found in System Information Page.

The steps below detail how to check the System Information number of an LD2 unit. 

  1. Press Page until you see the System Information menu
  2. Press Enter key to access the information.

Press Enter key to access the information