Configuring a Verify DP Heading input on PORT3 Configuring a Verify DP Heading input through USB For LD2 What is the expected latency from one PPS to the ZDA telegram? Guia rápido do LD2 da VERIPOS (LD2 Quick Guide - Brazilian Portuguese) How can I change the IP address of my LD2(S) when using Verify-DP? How can I determine what L-band firmware versions are installed on the LD2/LD2S? How do I check the GLONASS option on my Topcon GNSS Receiver in an LD2 IMU? How do I check the L-band reception status of my LD2/LD2S demodulator? How do I check version number of my LD2? How do I configure a Position Output on port P1 of my LD2/LD2S? How do I configure my LD2 (Topcon GPS card) to output a ZDA and 1PPS string from Port 1 of the LD2? How do I configure my LD2 to use the Apex service? How do I manually select MF Stations on my LD2 IMU? How do I Remove Standard+ Service in my LD2/LD2S? How do I select MF or HF Auto Frequency on my LD2? How do I upgrade the GLONASS option on my Topcon GNSS Receiver? I have just changed beams and my station list is not fully populated why is this? LD2 DP Bridge Card LD2 Installation Manual LD2 Operations Manual LD2 Quick Guide LD2 Setup - Configuring PPS & ZDA Output from Topcon GPS Card Selecting An LD2 L-band Beam What are the tracking capabilities of my LD2 and what services are available to my unit? What data is available on the LD2 Ethernet port? What do the status LED's on the front panel of the LD2 show? What is demodulator Channel 16 used for and how I configure it? What NMEA telegrams are available for output from the LD2/LD2S?

How do I Remove Standard+ Service in my LD2/LD2S?

As the Standard+ service has ceased, users are recommended to remove the Standard+ calculation from their LD2 / LD2S configurations. Users who were previously enabled for Standard+ as their highest service should enable their VERIPOS unit(s) for the VERIPOS Ultra Service.

Users only enabled for the VERIPOS Standard or Standard2 service do not need to disable Standard+ Service, However all other users should complete the following actions to remove Standard+ from their fall back solutions.

Remove Standard+ Calculation

This procedure stops the Standard+ corrections from being input into the VERIPOS algorithms within the LD2 / LD2S unit. As a result the Standard+ calculation will not initialise or be used.

From any point in the menu structure repeatedly press *Page* until the Main menu Configuration screen is displayed: 

Press *Enter* then press the *Page* key three or four times (depending if Beacon or HF/MF receiver is installed) to display: 

Press *Enter* then press the *Page* key three or four times (depending if Beacon or HF/MF receiver is installed) to display

Press *Enter* to display: 

Press *Enter* to display

If “Use STD Plus? Y” is displayed press *Toggle* then press the * Enter * to change it to “Use STD Plus? N”:

If “Use STD Plus? Y” is displayed press *Toggle* then press the * Enter * to change it to “Use STD Plus? N”

Reboot the LD2 by cycling the power to the unit using the power switch on the rear panel.