Configuring a Verify DP Heading input on PORT3 Configuring a Verify DP Heading input through USB For LD2 What is the expected latency from one PPS to the ZDA telegram? Guia rápido do LD2 da VERIPOS (LD2 Quick Guide - Brazilian Portuguese) How can I change the IP address of my LD2(S) when using Verify-DP? How can I determine what L-band firmware versions are installed on the LD2/LD2S? How do I check the GLONASS option on my Topcon GNSS Receiver in an LD2 IMU? How do I check the L-band reception status of my LD2/LD2S demodulator? How do I check version number of my LD2? How do I configure a Position Output on port P1 of my LD2/LD2S? How do I configure my LD2 (Topcon GPS card) to output a ZDA and 1PPS string from Port 1 of the LD2? How do I configure my LD2 to use the Apex service? How do I manually select MF Stations on my LD2 IMU? How do I Remove Standard+ Service in my LD2/LD2S? How do I select MF or HF Auto Frequency on my LD2? How do I upgrade the GLONASS option on my Topcon GNSS Receiver? I have just changed beams and my station list is not fully populated why is this? LD2 DP Bridge Card LD2 Installation Manual LD2 Operations Manual LD2 Quick Guide LD2 Setup - Configuring PPS & ZDA Output from Topcon GPS Card Selecting An LD2 L-band Beam What are the tracking capabilities of my LD2 and what services are available to my unit? What data is available on the LD2 Ethernet port? What do the status LED's on the front panel of the LD2 show? What is demodulator Channel 16 used for and how I configure it? What NMEA telegrams are available for output from the LD2/LD2S?

I have just changed beams and my station list is not fully populated why is this?

The station lists available on VERIPOS units are controlled via UCM’s (User Control Message) which are transmitted through the L-band beams from the VERIPOS Helpdesk. UCM’s only transmit station lists that are available to each specific beam. For example, UCM’s transmitted from 25E only have the stations that are available on 25E. The UCM for each unit is stored in a list which is transmitted in a constant loop.

When switching to a different beam the station list will not update until a UCM has been received. As a result new stations will not appear on the list; however the unit will keep receiving data for all common stations between beams until the new UCM is received.

The UCM specific for the unit will be in a list and could take from several minutes or up to 4 hours for the UCM to be transmitted depending on how long since the UCM for the unit was last transmitted, once the unit receives this the station list will then fully populate. If unable to wait up to 4 hours, the VERIPOS Helpdesk can be contacted and request a fresh UCM to be transmitted straight away to that specific unit.