AGRICULTURE
Accessing an LD4 Signal Status using L-band Control
How do I change the PPP Calculation of the LD4?
I have changed my PPP service and my LD4 solution has become unstable, how do I resolve this?
I have just changed beams and my station list is not fully populated why is this?
What is the PPS voltage of my LD4?
I have changed my PPP service and my LD4 solution has become unstable, how do I resolve this?
When switching between PPP services, the LD4 unit must have a power reboot performed. If the LD4 does not receive a reboot, the solution will become unstable.
To complete this, remove power from the LD4, wait 15 seconds and reapply power.
Note: When using an LD4 with a PPP service (Apex or Ultra), the user is able to change the selected PPP service being computed. To perform this action Septentrio Rx Tools software is required. The option to switch PPP service is found in the Rx control module. From the main menu select Navigation > Positioning Mode > Differential Corrections, then select the desired PPP service (if Apex and Ultra services are enabled on the unit):