AGRICULTURE
For LD7 What is the expected latency from one PPS to the NMEA ZDA telegram?
How do I change my LD7 IP address through USB?
How do I check the GNSS receiver firmware version on my LD7?
How do I check the IP address of my LD7?
How do I configure my LD7 to use the Apex service?
How do I Configure my PC to connect my LD7?
How do I configure the LD7 as an RTK Base Station?
How do I configure the LD7 as an RTK Rover?
How do I remove satellites from my LD7 (Septentrio GNSS) for DP Trials?
How do I set my LD7 to output 5Hz on com1 and com 2?
How do I set my LD7 to output HRP message?
I have changed my PPP service and my LD7 solution has become unstable, how do I resolve this?
I have just changed beams and my station list is not fully populated why is this?
LD7 Installation Manual
LD7 Operations Manual
LD7 Quick Guide
LD7 USB Drivers
I have changed my PPP service and my LD7 solution has become unstable, how do I resolve this?
When switching between PPP services, the LD7 unit must have a power reboot performed. If the LD7 does not receive a reboot, the solution will become unstable.
To complete this, press the power button on the front of the LD7, wait 15 seconds and press the power button again to restart the LD7.
Note: When using an LD7 with PPP service (Apex or Ultra) the user is able to change the selected PPP service being computed. To perform this action The LD7 Web Interface is used. Using the Google Chrome web browser type the IP Address of the LD7 into the address bar. When the LD7 Web interface page shows, type the user code of the unit and click OK. Click on the GNSS tab, change the PPP Mode and click Apply, followed by a power reboot to the LD7:
