AGRICULTURE
LD5 Equipment
- How do I check the IP address of my LD5?
- How do I check or change my LD5 L-band beam?
- How do I configure LD5 (C Variant) COM ports & Ethernet output?
- How do I enable and output heading from my LD5-C?
- How do I configure LD5 NMEA message output?
- How do I configure LD5 (A & B Variants) COM ports & Ethernet output?
- What direction is the heading on my LD5?
- How do I tell which LD5 version/variant I have?
- How do I manually enter an L-band satellite frequency on my LD5?
- How do I configure my LD5 to use the Apex service?
- How do I enable an LD5 for a heading?
- How do I configure an LD5 to receive RTK corrections?
- I have just changed beams and my station list is not fully populated- Why is this?
- What is the expected latency from one PPS to the NMEA ZDA telegram on the LD5?
- How do I change the cut off angle from my LD5-B or LD5-C for DP Trials?
- What are the serial pin-outs of the LD5?
- How do I remove satellites from my LD5-A for DP Trials?
- How do I set up cross corrections on an LD5 unit?
- What are the tracking capabilities of the LD5 and what services are available?
- How do I factory reset my LD5 Unit?
- How do you set up and log NMEA data from an LD5 unit?
- How do I extract LD5 internal data?
- I wish to enable External/MF corrections on my LD5-A for use in the position solution. Why is the 3rd Party menu item greyed out in the Routing menu?
- What are the different LD5 operating modes?