AGRICULTURE
LD6 Equipment
- How do I set up LD6 Outputs for VQC?
- How do I configure LD6 TRINAV Output?
- How do I configure NMEA sentences on LD6 versions 101 and 105?
- How do I configure NMEA Sentences on an LD6 versions 8 or 50?
- How do I check the IP address of my LD6?
- How do I change a beam on an LD6?
- How do I enable and output a heading from an LD6?
- What version of GNSS card is installed in my LD6?
- What files should I send for data analysis from a LD6 while running quantum on board?
- What direction is the heading on my LD6?
- How do I manually enter an L-band frequency on the LD6?
- How do I configure my LD6 to use the Apex service?
- How do I configure an LD6 to receive RTK corrections?
- How do I check which version of LD6 I have?
- How do I correctly shut down a LD6?
- I have just changed beams and my station list is not fully populated- Why is this?
- What is the expected latency from one PPS to the NMEA ZDA telegram on the LD6?
- What are the serial pin-outs of the LD6?
- How do I remove satellites from my LD6 version 8 or 50?
- What is the PPS voltage and pulse width of my LD6?
- How do you load a Verify QC config onto the LD6 while in QC mode?
- How do I enable SBAS on my LD6 IMU?
- What are the tracking capabilities of my LD6 and what services are available to my unit?
- How do I check the GNSS tracking capabilities of my LD6 version 8 or 50?
- How do I factory reset my LD6 unit?
- How do I archive data on an LD6?
- How do I implement a basic LAN interface between an LD6 and my Verify QC computer? (v1.11 or later)
- What is the best way to interface Verify QC to my LD6 units?
- How do I interface my antennas to the LD6?
- How do I change the PPP solution when my LD6 is enabled for both Apex and Ultra services?
- How can I interface RTCM data from two LD6 units to Verify QC using a single LAN connection (Dual beam corrections)?
- What data is available on the LD6 Ethernet ports?