AGRICULTURE
How do I apply an LD900 Authorisation Code?
How do I set up an NMEA output on LD900 COM or ICOM Port?
What ports are available for LD900 TCP/IP or UDP connection?
How do I access my LD900 archive logs?
How do I activate, configure and enable heading on an LD900?
How do I activate my LD900 for Veripos services?
How do I change my LD900 IP address?
How do I change the PPP calculation of my LD900?
How do I check or change my LD900 L-Band beam?
How do I configure my PC to connect to an LD900?
How do I convert LD900 logged data into RINEX format?
How do I enable and configure my LD900 to receive Veripos Corrections via NTRIP?
How do I find my LD900 IP address?
How do I tell which model of LD900 I have?
How do you apply an Auth Code to an LD900?
What direction is the heading on my LD900?
What is HDR Mode on the LD900?
What is the Auto L-band beam?
Why can I not connect to the LD900 TCP/IP ports?
How do I access my LD900 archive logs?
Insert a virus-free, FAT32-formatted USB drive into the LD900 front panel USB port.
To archive data from the LD900 navigate to Receiver > Export.
Within the Export page, the Export Now option is available. In the event of receiver issues such as loss of solution, this option provides a method for exporting data to a USB drive for further analysis.
The LD900 will retain the last 72 hours of logs. When exporting data for analysis by Veripos support it is recommended to provide data commencing from three hours prior to an event until one hour after.