AGRICULTURE
How do I apply an LD900 Authorisation Code?
How do I set up an NMEA output on LD900 COM or ICOM Port?
What ports are available for LD900 TCP/IP or UDP connection?
How do I access my LD900 archive logs?
How do I activate, configure and enable heading on an LD900?
How do I activate my LD900 for Veripos services?
How do I change my LD900 IP address?
How do I change the PPP calculation of my LD900?
How do I check or change my LD900 L-Band beam?
How do I configure my PC to connect to an LD900?
How do I convert LD900 logged data into RINEX format?
How do I enable and configure my LD900 to receive Veripos Corrections via NTRIP?
How do I find my LD900 IP address?
How do I tell which model of LD900 I have?
How do you apply an Auth Code to an LD900?
What direction is the heading on my LD900?
What is HDR Mode on the LD900?
What is the Auto L-band beam?
Why can I not connect to the LD900 TCP/IP ports?
How do I activate my LD900 for Veripos services?
Access to Veripos Correction Services requires a valid subscription before they can be activated on the LD900.
To activate Veripos services on the LD900 the user must send a service activation request (containing the unit User Code, Vessel Name, SAL number and services required) to the Veripos Support. Once processed, the activation will then be sent via L-band satellite to the unit.
Upon activation, the unit will start using Veripos services. To verify the unit is activated navigate to Receiver > Authorisations, this page will display the services which are activated:
Note: The default PPP mode is Apex, to switch to Ultra navigate to Configuration > Positioning. Further info can be found in FAQ How do I change the PPP calculation of my LD900?