How do I enable and configure my LD900 to receive Veripos Corrections via NTRIP?

To use the NTRIP service, this requires to be activated through service activation from the Veripos Helpdesk to become accessible via the unit. This will require providing the Helpdesk with the unit ID number and the SAL code. For the activation to be receiver ensure that the unit is locked to an L-band beam as the activation will be sent via the L-band signal. 

To configure LD900 to receive Veripos corrections via NTRIP, first make sure that the unit is connected to the internet and confirm that port 2101 is open on the vessel network for connection to sid-output.com (browse to sid-output.com:2101). The NTRIP data will be made through the LD900 LAN1 and this port should be used for network connection.

Once the above has been achieved and confirmed, navigate form the LD900 home screen to Configuration > Corrections > NTRIP then click on Edit and select On for the NTRIP Mode then click Apply. 

To confirm that NTRIP is configured correctly and the LD900 is receiving the Veripos corrections via NTRIP, navigate to Status > Corrections > Veripos and the radio button next to NTRIP should turn green when the receiver is unable to track an L-band beam simulating an outage.