AGRICULTURE
How do I apply an LD900 Authorisation Code?
How do I set up an NMEA output on LD900 COM or ICOM Port?
What ports are available for LD900 TCP/IP or UDP connection?
How do I access my LD900 archive logs?
How do I activate, configure and enable heading on an LD900?
How do I activate my LD900 for Veripos services?
How do I change my LD900 IP address?
How do I change the PPP calculation of my LD900?
How do I check or change my LD900 L-Band beam?
How do I configure my PC to connect to an LD900?
How do I convert LD900 logged data into RINEX format?
How do I enable and configure my LD900 to receive Veripos Corrections via NTRIP?
How do I find my LD900 IP address?
How do I tell which model of LD900 I have?
How do you apply an Auth Code to an LD900?
What direction is the heading on my LD900?
What is HDR Mode on the LD900?
What is the Auto L-band beam?
Why can I not connect to the LD900 TCP/IP ports?
What is HDR Mode on the LD900?
The High Dynamic Range (HDR) mode assists the L-band tracking by using signal processing to reduce the effects of RF interference. Enabling HDR mode will improve rejection of erroneous signals which can impact the received L-band signal.
When HDR mode is active the processing and power load on the GNSS receiver will increase.
HDR Mode is Off by default. To enable or disable HDR Mode, navigate from the LD900 home screen to Configuration > Corrections > L-band then select Edit for the HDR Mode and use the arrow keys to select On or Off, followed by pressing the tick. Finally use the arrow keys and tick to select Apply, right to select Yes and tick to apply the change:
